Recoating your façade and roof

Depending on the substrate and situation, the lead time for façades is about 1-1.5 weeks for a space measuring 40 x 25 x 7 m.

We operate both within the Netherlands and abroad. We are primarily active in the Netherlands, Belgium and Germany. However, some of our projects take us far beyond this scope.

We use systems and products that seamlessly fit the products by suppliers / coil coat manufacturers. Depending on the type of coating, substrate and finish, these include water-based and solvent-based systems. We usually make an on-site assessment and, based on this, provide advice or present a quote.

• We clean, remove loose parts and degrease the surface with a high-pressure cleaner. If necessary, we manually brush the surface with a biodegradable detergent. That way, the surface that needs to be coated is sufficiently clean and grease-free. Once the surface has dried, we can start applying the paint system.
• Components that should not be coated (frames, façade sections, gutters, doors, obstacles, etc) are covered.
• We then apply an adhesive coat / primer that will form the foundation for the sealing coat.
• Afterwards, we apply a top coat, sealing coat over the primer.
• The product is applied through airless spraying (no air, just the coating material), to keep spray mist to an absolute minimum.
• This application method is both environmentally friendly and responsible from a health and safety point of view.

We work with the following suppliers, among others:

• Kingspan panels
• SAB panels
• Hoesch / Hobone
• Arcelor Mittal
• Joris Ide
• Plaum
• Trimo
• Cladding Point
• Falk
• Van Delft Profielen
• Salzgitter Bauelemente
• Itapanelli
• Hardeman Veenendaal
• Isocab
• Brucha
• Paroc
• Unisol
• KIM
• Beckers
• Colpro
• Holland groep

We can mix and spray any colour, even special, custom ones. Moreover, we can also apply Metallic and mother-of-pearl-effect colours.